Be sure that the clock will not shift on the wall when the door is opened.
How turn on the chime on hermle wall clock.
Mounting wall clock models.
It arrived not working correctly.
I read and re read the thread on chime clock basics to try and understand what was happening or not happening and still need some help.
It keeps time just fine but the chimes are not functioning correctly.
Choose between bim bam westminster whittington and ave maria chimes.
How to stop a clock chime.
I am working on a newly acquired hermle westminster chime movement.
Pull gently on the knob to move it into the setting.
Check the position of the minute hand of the clock when the top of the hour strike occurs.
5 attaching the pendulum.
Determine if you d like to shut the chimes down altogether or just at night.
To wind the clock use the enclosed key.
If it is a few minutes before or after the hour.
Turn key clockwise until it stops about 3 1 2 turns on the left winder and about 4 1 2 turns on center and right winder.
To wind the clock use the enclosed key.
Open the access panel door to the pendulum and bring it to a stop.
Turn key clockwise until it stops about 3 1 2 turns on the left winder and about 4 1 2 turns on center and right winder.
Allow the clock to complete its sequence of chimes and then allow the clock to exit the chime phase which safely will be half way between.
Turn the knob to the desired chime option and press the knob to make your selection.
Wind the center winder until the weights are at the top.
Hang your clock vertically to the desired location.
How to adjust chime clocks.
Start pendulum by moving it approximately 1 1 2 inch to the left or right and releasing it.
Remove the minute hand retaining nut.
Set the chime on your hermle 1217 clock with the second knob.
By setting the switch to the position and the melody switch to b the clock with movement w2114 or w2214 will strike bim bam every hour and half hour.
The center winder is for the timekeeping the right winder is for the quarter hour chime and the left winder is for the hour strike.
Take a look at the clock controls.
The center winder is for the timekeeping the right winder is for the quarter hour chime and the left winder is for the hour strike.
Step 5 locate the clock s analog knob in the center of the clock.
Wind the clock gently so the weights do not suddenly reach the stopping point at the top.
An easy way to assemble any hermle chime movement.
By setting the switch to the position and the melody switch to w the clock will chime the westminster melody on the hour only followed by the hour strike.