With screws inspect the lever and faceplate on both sides of the door and locate the single mounting screw on the lever shaft and two or more screws on the faceplate.
How to take off lever door handle.
If your knob has a pinhole or small slot opening use a flathead screwdriver to push it inward.
Using a philips head screwdriver turn counterclockwise to unscrew a knob with standard hex head screws.
Once triggered the lever or lock trim can be removed from the door.
Find the screws on the side of the door that secure the latch plate.
Apply a bit of pressure to the paper clip to trigger a release button inside the hardware.
Use a philips head screwdriver to unscrew them.
Begin by holding the door knob securely in place.
This is a simple straig.
Look for pin holes in the rose or in the lever body itself.
Take out the screws then carefully pry off the plate with a flat head screwdriver.
With the plate removed you can now pull the latch mechanism through the side of the door.
The door handle will now slide off.
Use a screwdriver to remove the set screws which will release the lock and lever from the opening.
You would be surprised how a simple job like removing a door handle or doorknob can be a frustrating experience if your not prepared.
If any screws are exposed during this process remove them to release the lock and remove it from the door.
Step 1 unscrew the door lever handle in order to get at the screws that hold the handle to the door you need to expose them by removing the plate that surrounds the lever handle also known as a rose.
If not rotate the faceplate until the underlying screws are accessible and use a phillips head screwdriver to remove them.
Diy remove replace door s handle with hidden screws.
Screw heads may be of the.
Depending on the door handle design the faceplate may be able to slide completely off.
A paperclip or small pin can also be used if the screwdriver is too big.
Straighten a paper clip and insert it into the hole.
Straighten a paper clip and insert it into the hole.
You can usually twist or pry it off with a flathead screwdriver to expose the screws.