How To Take Apart Door Handle Without Screws

Our quick video shows you how si.

How to take apart door handle without screws.

There should be a small latch near the base of the knob or handle probably on the exterior side of the door. Remove door knob without screws. Diy remove replace door s handle with hidden screws. Apply a bit of pressure to the paper clip to trigger a release button inside the hardware.

Depending on the door handle design the faceplate may be able to slide completely off. If any screws are exposed during this process remove them to release the lock and remove it from the door. To remove a door handle without any visible screws start by prying off the cover plate by inserting a flathead screwdriver in the notch on the side of the plate. Take your flat philips screwdriver and place it in the gap.

You should see a tiny slot or hole. The door handle will now slide off. Push this latch in and pull the handle off the door. If you can t see any screws don t worry they re there.

Look for the tiny gap on the side of the door knob. Next find a small slot on the edge of the trim piece. Pull the screws from the. Many door knobs have trim plates that cover the screws so removing them can be a bit tricky if you ve never done it before.

With some pressure you can move the clip inside. Slide the cosmetic faceplate away from the door. How to remove a door knob without screws or a latch locate the hole underneath the doorknob shaft. If you don t see a notch and the cover plate is round try turning the plate counterclockwise to remove it.

Straighten a paper clip and insert it into the hole. If not rotate the faceplate until the underlying screws are accessible and use a phillips head screwdriver to remove them. If the plate is difficult to remove by hand insert a flat head screwdriver under the edge of the plate plate where it meets the door surface prying outward using gentle pressure. Once triggered the lever or lock trim can be removed from the door.

Keep one hand on the outside section of the door knob to keep it from falling on the floor. After applying some pressure you can pull the door knob towards you. Turn each screw holding the knob body to the door with a phillips screwdriver.