2 turn the black hand setting knob in the direction indicated on the back of the movement.
How to set a regulator wall clock.
To start clocks with a pendulum reach through the front door of the clock and place your hand on the side of the pendulum disk.
Grasp the time setting knob between a thumb and.
Video tutorial showing how to install an antique vienna regulator wall clock.
For all clocks starting clock clocks withouta pendulum will start automatically if the clock is wound.
If the pendulum stays in the clock it may scratch the inside of the case as well as change the beat and then the clock may not work.
Rotate the rating square to center it if needed.
Loosen the adjustment nut to slow the clock down or tighten the nut to speed it up.
Wait 24 hours then compare the time on the regulator clock to the time displayed by an accurate time source to.
Once the movement has been installed in your clock case using the center fixation nut you are ready to set the chimes.
Secure the screw into the wall angled upward at a 45 degree angle and hang the clock.
How to set a regulator clock.
Choose the proper size wood screw typically a 8 10 or 12 to fit the hanger at the top back of the clock and long enough to go securely through the wall into a stud.
Video tutorial showing how to install an antique vienna regulator wall clock.
Rotate the minute hand.
The hour hand and minute hand will move as well.
If the hands are sticking or meeting up at any time during the day gently level them out over the face of the clock with a small set of needle nose pliers.
Place a forefinger at the tip of the minute hand and turn it clockwise to the correct time.
Turn this knob until a feint click is heard.
Synchronize the regulator clock to a known accurate time source such as the time displayed on a cellphone or computer.
1 install a fresh c cell battery in the position indicated in the battery well.
Setting the clock on time it does not chime properly permit it to operate 12 hours to correct itself.