If the sink is wide enough the bracket might overlap at least two of the wall studs and if so you may be able to anchor it to the studs with lag screws.
How to secure a wall mount bathroom sink.
Use the drywall saw to cut through the drywall to access the wooden studs.
No under cabinet storage for the comet recommended.
After driving in the first fastener check to make sure the sink or mounting plate is level then drive in the other fasteners.
No vessel sink here.
2 use lag screws or other fasteners recommended by the manufacturer to secure the sink or the sink s metal mounting plate to the blocking.
A wall mount sink hangs from a bracket which is supplied with it and the bracket has to be mounted to the wall framing not to the wallboard.
The sink is formed seamlessly as part of the counter.
Some wall mounted sinks have a metal hanging bar that attaches to the wall.
Fasten the sink to the wall with mounting screws.
Wall mount counters are the perfect solution for the ultra small bathroom.
Secure the sink or mounting plate to the wall.
Mount the sink to the wall.
Attach a steel clip at each corner with a screwdriver clamping the sink to the underside of the countertop.
Install any sink clips below the counter if the sink s installation calls for them.
Lift the sink slightly while tightening the nuts with a wrench.
Step 3 close the wall.
Silicone caulking is still used on rimmed sink installations to seal out water.
Advanced adhesives specifically for granite counter tops are the choice here.
Step 9 screw on clips photo by wendell t.
Mounting a vanity sink to a granite bathroom counter top requires another type of glue one that bonds to granite and the sink surface.
Cut the 2x4 lumber to size to fit between the studs.
It acts as a protective barrier.
Wipe the dust from the countertop.
Slip the sink over the mounting bolts and finger tighten the mounting nuts over the washers.
Spread a bead of silicone caulk on the sink s flange and tip the sink in place.
Apply adhesive to the sink photo by wendell t.
Use epoxy to attach the clips to the underside of the sink and the bolt stems to the underside of the counter.
Smear pipe dope onto the threads of the supply line compression fittings and tighten them onto the faucet supply lines.
Secure it so it is level and then slide the sink onto the hanging bar.