1 part type s masonry cement to 2 5 parts sand.
How to scratch coat a concrete wall.
Thanks for watching.
You can scratch it right after you apply it to the wall but it will take a bit more control on your part to.
After you have an even and uniform amount of mud on the wall you will want to use a scarifier notched trowel or something along those lines to make the scratch marks in the material.
The process involves applying a layer of cement over the concrete block wall to cover.
Mixing the scratch coat.
Skim coating can freshen up old concrete blocks and give your home or a wall on your property a new look.
By nathan giffin of vertical artisans.
If you re using the mortar to hold on stone veneer the mortar should be scraped onto the back of the stone and then pressed into the scratch coat.
This step is not necessary when applying stone veneer to a cleaned concrete masonry or stucco surface.
Add the scratch marks.
I have even said a scratch coat makes or breaks the job.
Diy stucco using quickcrete stucco base scratch coat and bonding adhesive.
In addition some concretes are quite porous and will rob water from your repair.
Apply a 1 4 in 0 64 cm scratch coat with a trowel.
Dry mix the sand and cement together and avoid creating clumps in the mixture.
It works best if the mud sets up for 5 10 min before scratching the surface.
Cover the lath with a scratch coat of mortar to.
A scratch coat will be needed when metal lath is used.
Scratch coats are particularly important in the world of vertical decorative concrete.
If you are doing a large area and a scratch coat isn t practical you will need to spray the surface with water before you apply the repair material.
If you have a concrete sprayer use it to cover large areas quickly.
I say this because in vertical decorative concrete contractors must lay up a lot more than a regular plaster application.
On a warm day the existing concrete surface will be hot enough to suck the water out of the repair material.
Otherwise try picking up the stucco mix with a flat tool like a hawk and then transferring it to the wall with a trowel.
The mortar that squishes out over the stone will then form the mortar joint between that stone and the next stone.