The main goal is to give your door a little tooth for the new paint or primer to adhere to.
How to sand a 6 panel door.
Brush on the second coat following the same order and let it dry overnight.
For cracks in the door scrape or sand off any rough or raised edges.
Lightly sand the primer with 220 grit inspecting as you go.
This free video diy guide provides some much need help.
Happily refinishing a door is easier than you might think.
Put down drop cloths.
Paint the edges and wipe off the slop.
A good sand job on a heavily detailed cabinet door shouldn t take more than 15 minutes 7 8min per side.
When that s dry reattach the door hardware.
Back off the sandpaper and use a synthetic steel wool 3m multi flex is what i use for the raised panel and detail parts of the door.
Sand the door again with 150 grit followed by 220 grit sandpaper.
Dust and sand with 280 grit paper then put on the final coat.
It s so easy in fact that this clip can present a complete overview of the process in just over two and a half minutes time.
Be sure to sand down any bumps or blemishes.
A couple of quick passes is all it takes.
Use 120 grit sandpaper to gently sand the door for a smoother surface that will absorb primer or paint more easily.
Hand sand small spots or leave them and sand it while sanding your door.
Brush all of the sanding dust off of the door with an old soft bristle paintbrush or use a shop vac to suction it off.
Lightly sand the entire door.
The longer it dries the better it will sand.
Let the primer dry overnight before sanding.
Turn the door over and repeat all of the previous steps.
Before painting clean the door with a degreasing cleaner.
Remove the hinges deadbolt door knob and any other hardware.
Use a section of 220 grit hand sandpaper to sand the area around the raised panels.
After sanding remove dust from the area before priming or painting.
Dust the door and wipe it down with a tack cloth.
Brush or roll paint onto all four edges.
Use a hand figuring out how to go about refinishing a pine door.
Place a 220 grit sanding disc on the orbital sander and sand all of the flat areas again.
No need to bust out the power sander you can use a sanding block or sheet of sand paper.
Wipe off the door with a damp rag to remove any sawdust.
Fill holes and repair imperfections with sandable filler or spackle.
Sand the door down to bare wood with 100 grit sandpaper.